1956-70 VW Beetle Floor Pan – Driver Side (Left Half)

Brand New Replacement Driver Side Floor Pan for 1946-1970 VW Beetle Complete with seat rails and jack mount Inverted “L” seat rails (specific to 1946-1970 VW Beetles) Full length and width floor pan half Made from 0.035″ (20 Gauge) sheet metal This Brand New Replacement Driver Side Floor Pan is a full-length and width half, designed to fit 1946-1970 VW Beetles. It features the inverted “L” seat rails, which are specific to these model years (note that 1971-72 floor pans have “T” seat rails). Product Fitment 1946-1970 VW Beetle Important Installation Notes The rear crossmember and jack support may not be welded to the floor pan. To keep prices low, we ship these pans with loose pieces, which allows us to use a smaller box. Many installers recommend using the original crossmember, which saves time during installation as the crossmember does not have to be removed from the replacement pan. The process is covered in our floor pan installation video. Installation will require cutting and welding the inner edge to the chassis, just like the original factory floor pans, while the outer edge bolts to the heat channel. A replacement pan to body seal and floor pan hardware are recommended whenever installing new floor pans. We also recommend replacing the seat rail bushings when installing new floor pans. Notes on Sheet Metal: Virtually all sheet metal parts are sent with a black, sprayed-on, rust inhibitor. This is NOT a paint or a primer. The black paint that comes on most sheet metal itemsmust be removed before applying primer to the sheet metal. Expect scratches, minor dents, dings, and imperfections. These are considered normal. You will likely have to perform minor body work on any aftermarket sheet metal during the installation and restoration process. This is a universal issue across the entire classic car industry due to the nature of the product. Large dents would be considered excessive damage. All sheet metal is carefully inspected prior to shipping for any major dents. Any sheet metal that is received dented must be presented to the shippingcarrier for a damage claim, regardless of the condition of the box. Test fit the all sheet metal before painting. Once body work or paint work has been done to any sheet metal item, it can’t be returned! There are no exceptions!