Hand lever large flow fire monitor This product is large flow monitor with functionality for adjusting the water flow in five segments. In addition, it has a stationary monitor with an angle that can be adjusted horizontally and vertically and can switch between water mist and a water column. It can accomplish heat insulation with a water curtain, cooling, and fire extinguishing for dangerous areas where fires can break out easily, such as oil tank areas, chemical plants, machinery rooms, solvent warehouses, oil filling plants, etc. Distance between bottom flange and operating lever center joint: approx. 450mmThis product is large flow turret with functionality for adjusting the water flow in five segments. In addition, it has a stationary monitor with an angle that can be adjusted horizontally and vertically and can switch between water mist and a water column. It can accomplish heat insulation with a water curtain, cooling, and fire extinguishing for dangerous areas where fires can break out easily, such as oil tank areas, chemical plants, machinery rooms, solvent warehouses, oil filling plants, etc. This product consists of a body, elbow, water outlet, nozzle that supports water mist and water column, and hand lever. The water enters the body from the bottom, and the water current is concentrated through the elbow at the water outlet and sprayed from the water mist or water column nozzle. The operator uses the hand lever to control the spraying angle and position and spray the water to the source of fire to extinguish it. In case the temperature of the fire scene is too high, the operator can use the water mist nozzle to isolate the radiating heat to protect themselves and prevent the fire from spreading. In a dangerous area, the operator can fix the monitor at any angle set it to water mist or water column and then leave the scene. The angle of the monitor will remain fixed during the spraying. An automatic water escape valve is installed at the water inlet flange of the monitor. When the water pressure reaches 2 kgf/cm2 or higher, the valve will be automatically closed. When the operation is finished and the pump is turned off, the valve will drain the remaining water from the monitor. Hand lever large flow fire monitor Model CD-HM292 CJ1250 Nozzle joint size 2-1/2" NHT or 3"-12UN internal thread joint (matches the water outlet of the body) Size of turret joint 4" ANSI 150# FF or RF flange Operating pressure 200PSI (14 kgf/cm2) Test pressure 300PSI (21 kgf/cm2) Adjust angles vertically -45° (depression angle) ~ 85° (elevation angle); a lock is attached so the product can be fixed at any angle Adjust angles horizontally 360° rotation; a lock is attached so the product can be fixed at any angle Material Body, elbow, water outlet: BC6 Operating lever: SUS304 Nozzle: BC-6 chromium plating Water mist/water column No segment adjustment Water flow adjustment range 5 segments:350, 500, 750, 1000, 1250GPM Range With water pressure of 100psi (7kgf/cm2) Straight water column: Spray range over 80m Pure water mist: Spray range over 35m Total weight Approx. 34kg Operating lever range: approx. 450mm Distance between bottom flange and operating lever whirligig center approx. 450mm
